This Sankey Tap Conversion Kit allows you to directly connect Pin Lock Quick Disconnect fittings that are already installed in your system, to a Sankey Keg Tap (commercial keg tap).
INCLUDES:
- (2) MFL Tailpieces & Flare Washers04C03318
- (2) Quick Disconnect Post Adapters (04C03317)
- (2) Quick Disconnect Tank Posts (1 gas, 1 liquid) (15C07106 & 15C07107)
- (2) Poppet Valves for Tank Posts
Instructions:
- Remove barbed end fittings from Sankey Keg Tap
- Insert MFL Tailpiece into locking nut
- Screw on the QD Post Adapter to MFL Tailpiece, tighten
- Screw on the QD Tank Post (with poppet inside) to QD Post Adapter, tighten,
- Install locking nut onto keg tap. Make sure rubber washer below Tailpiece is in place, tighten.
