DRAFT TOWER COOLER
This beer tower cooler is designed to cool the beer inside a Draft Tower.
With most all beer coolers, the beer keg is stored in a refrigerator or cooler right below the beer tower. The problem is that the cold air does not get up into the Tower to keep the beer and shank cold there...so you get warm, foamy beer for your first 1/2 glass!
The solution is less than 5 minutes away - just install our tower cooler.
Our tower cooler works by continuously blowing a small volume of cold air into your beer tower and the cold air keeps your beer shanks and faucets ice cold. A side benefit is that the continuous cold keeps faucet mold and bacteria growth at an absolute minimum.
Installs in minutes with no tools!
- Unpack the beer tower cooler.
- Push the open end of the cooler hose up into your beer tower until it stops. Use the supplied nylon zip-tie to tie the hose to your beer lines.
- Plug the power supply into a wall outlet or extension cord.
- Run the thin power cable past the kegerator door and plug into the Beer Tower Cooler. For a cleaner looking install, you may want to run the power cord through a small hole you drill through the side or back of your kegerator. Be careful to avoid refrigerant lines if you decide to do this.
