WINE DRAFT TOWER - 4 FAUCET
- 4" diameter column
- Draft tower especially built for dispensing wine.
The Draft Tower's exterior is a polished stainless steel. This will look good in all wine bars and restaurants. It is 4" in diameter & 14" high. You will need to cut a hole in the countertop for the lines to run through and then bolt the tower to the countertop.
The Shanks and Faucets are all stainless steel, not chrome plated brass. NO chemical/acid reactions will occur. Mirror finish polished stainless steel body.
The Wine Tower comes with 5' of 3/16" I.D. beverage hose with a stainless steel stainless swivel nut to attach to the wine tap. If you do not have an all stainless wine Sanke keg tap, click here, and you will also need a stainless MFL connector (MFL - 04C03318IH) ; click here.
If you are using ball lock kegs you will need a stainless Quick Disconnect fitting (07E04295IH), click here.
Don't forget about the Drip Tray.
- Height:14"
- Diameter:4"
- Center Faucet Height:11-1/8"
- Side Faucet Height: 10-3/8"
WARNING: An Error occurred, please refresh the page and try again.
